Last Updated on October 29, 2020 by Admin
Refer to the exhibit. An administrator is attempting to install a default static route on router R1 to reach the Site B network on router R2. After entering the static route command, the route is still not showing up in the routing table of router R1. What is preventing the route from installing in the routing table?
- The netmask is incorrect.
- The destination network is incorrect.
- The exit interface is missing.
- The next hop address is incorrect.
Answers Explanation & Hints:
The next hop address is incorrect. From R1 the next hop address should be that of the serial interface of R2, 184.108.40.206.