A network administrator is using the router-on-a-stick method to configure inter-VLAN routing. Switch port Gi1/1 is used to connect to the router. Which command should be entered to prepare this port for the task?

Posted on By Admin

Last Updated on October 29, 2020 by Admin

A network administrator is using the router-on-a-stick method to configure inter-VLAN routing. Switch port Gi1/1 is used to connect to the router. Which command should be entered to prepare this port for the task?

  • Switch(config)# interface gigabitethernet 1/1
    Switch(config-if)# spanning-tree vlan 1
  • Switch(config)# interface gigabitethernet 1/1
    Switch(config-if)# spanning-tree portfast
  • Switch(config)# interface gigabitethernet 1/1
    Switch(config-if)# switchport mode trunk
  • Switch(config)# interface gigabitethernet 1/1
    Switch(config-if)# switchport access vlan 1

    Answers Explanation & Hints:

    With the router-on-a-stick method, the switch port that connects to the router must be configured as trunk mode. This can be done with the command Switch(config-if)# switchport mode trunk . The other options do not put the switch port into trunk mode.

For more question and answers:

Click Here CCNA 2 SRWE v7 – SRWE Practice Final Exam Answers Full 100%

Uncategorized